Prep LED Strip 

Cut the LED strip to 60 pixels long, half of the 120 pixel strip. Measure and cut wires to solder to the pads on the two strips. Leave the silicone sheathing over the pads to protect the connections.

Pull the silicone sheathing back over the pads after wires are soldered. 

The wires can be marked with oil based white marker to distinguish connections.  

Fit Strip in coil

Thread the two LED strips into the Coil part.

Place Lipo battery

Place the Lipo Battery with the wires first into the battery holder on the handle. 

Attach Handle 

Use M2x8mm screws to connect the Coil part.

Solder Slide Switch

Measure wires for the slide switch to reach were the Feather board mounts to other the handle, about 120mm.

Attach Right Angle USB C Dongle

Plug in the right angle USB C dongle facing the cut out on the handle. 

Terminal Wires

Match and pair the two LED wire connections together to fit into the terminal block.

Speaker Socket Wire

Measure and cut a 60mm long Pico Blade Socket wire to easily connect the Oval Speaker, into the terminal block. 

Place board screws

Add screws to mount the Feather board to the standoff on the handle. Place the Lipo Battery wire under the board before fastening to the standoffs.

Plug Lipo Battery

Plug in the Lipo Battery to the Feather before fastening the screws to the standoffs on the handle.

Mount Feather 

Fasten screws to the handle.

Arrange LED strip

Tuck the LED strips under the Lipo Battery holder on the handle. 

Press Fit the Speaker

Align the speaker wire to the cutout on the cavity and press fit into the handle.

Press Fit the Slide Switch

Angle the slide switch and press fit into the cutout on the handle.

Align handle 

Place the handle over the Coil part and fasten with four M2x8mm long screws. 

Attach Bottom

Align the Bottom part to the handle and fasten with four more M2x8mm screws.