Angled shot of a Adafruit METRO 328 Fully Assembled
We sure love the ATmega328 here at Adafruit, and we use them a lot for our own projects. The processor has plenty of GPIO, Analog inputs, hardware UART SPI and I2C,...
Out of Stock
Adafruit HUZZAH CC3000 WiFi Breakout with Onboard Antenna
For years we've seen all sorts of microcontroller-friendly WiFi modules but none of them were really Adafruit-worthy. Either they were too slow, or too difficult to use, or...
Discontinued
DHT11 basic temperature-humidity sensor with 10K resistor
Discontinued - you can grab the DHT20 - AHT20 Pin Module - I2C Temperature and Humidity...
Discontinued
DHT22 temperature-humidity sensor with 10K resistor
The DHT22 is a basic, low-cost digital temperature and humidity sensor. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air and spits out a digital...
Discontinued
Sensor module with three wires
Discontinued - you can grab AM2301B - Wired Enclosed AHT20 - Temperature and Humidity Sensor instead!The...
Discontinued
Angled shot of half-size solderless breadboard with red and black power lines.
This is a cute, half-size breadboard with 400 tie points, good for small projects. It's 3.25" x 2.2" / 8.3cm x 5.5cm with a standard double-strip in the...
Out of Stock
Premium Male/Male Jumper Wires - 20 x 6 (150mm) folded over
These Male/Male Jumper Wires are handy for making wire harnesses or jumpering between headers on PCB's. These premium jumper wires are 6" (150mm) long and come in a...
$1.95
In Stock