Top down view of a FLORA - Wearable electronic platform: Arduino-compatible connected to 4 alligator clips and a USB powerin the FLORA.
FLORA is Adafruit's fully-featured wearable electronics platform. It's a round, sewable, Arduino-compatible microcontroller designed to empower amazing wearables projects.FLORA...
guides with product
$14.95
In Stock
Angled shot of VS1053 Codec board.
This breakout board is the ultimate companion for the VLSI VS1053B DSP codec chip. The VS1053 can decode a wide variety of audio formats such as MP3, AAC, Ogg Vorbis, WMA, MIDI, FLAC,...
guides with product
$24.95
In Stock
Angled shot of blue, rectangular stereo audio amplifier breakout with green terminal blocks.
This incredibly small stereo amplifier is surprisingly powerful - able to deliver 2 x 2.1W channels into 4 ohm impedance speakers (@ 10% THD). Inside the miniature chip is a class D...
guides with product
$9.95
In Stock
IR (Infrared) Receiver Sensor plugged into breadboard
IR sensor tuned to 38KHz, perfect for receiving commands from a TV remote control. Runs at 3V to 5V so it's great for any microcontroller.To use, connect pin 3 (all the...
$1.95
In Stock
Mini Remote Control with 21 buttons
This little remote control would be handy for controlling a robot or other project from across the room. It has 21 buttons and a layout we thought was handy: directional buttons and...
$4.95
In Stock
Overhead shot of four, black, round LED breakouts.
What's a wearable project without LEDs? Our favorite part of the Flora platform is these tiny smart pixels. Designed specifically for wearables, these updated Flora NeoPixels have...
guides with product
$6.50
In Stock
Lithium Ion Polymer Battery 3.7v 1200mAh with JST 2-PH connector
Lithium-ion polymer (also known as 'lipo' or 'lipoly') batteries are thin, light, and powerful. The output ranges from 4.2V when completely charged to 3.7V. This...
Out of Stock
Lithium Ion Polymer Battery 3.7v 2500mAh with JST 2-PH connector
Lithium-ion polymer (also known as 'lipo' or 'lipoly') batteries are thin, light, and powerful. The output ranges from 4.2V when completely charged to 3.7V. This...
Out of Stock
USB LiIon/LiPoly charger.
This is a Lithium Ion and Lithium Polymer battery charger based on the MCP73833. It uses a USB mini-B...
guides with product
$12.50
In Stock
Hand removing/installing micro SD card from SD adapter
Add mega-storage in a jiffy using this 8 GB class 4 micro-SD card. It comes with a SD adapter so you can use it with any of our shields or adapters. Preformatted to FAT so it works out...
$9.95
In Stock