3D Print Enclosure

Save Subscribe
leds_uv-manicure-lamp-printing-parts.jpg

uv-frame.stl
uv-bottom-cover.stl
uv-top.stl
uv-eyes.stl
uv-tray.stl
uv-bottom.stl

PLA @230c
0.2 Layer Height
2 Shells
10% Infill
90/120 speeds

Takes about 4-5 hours to print all parts

All of the parts are optimized to print with out support material. We recommend printing in PLA material with the slice settings above for best results. Print the eyes in a contrasting color!

leds_uv-manicure-lamp-3d-parts.jpg
leds_uv-manicure-lamp-glue-eyes.jpg

The enclosure is held together with machine screws, but you'll have to glue the eyes in place. We recommend E6000 but hot-melt glue would work just fine too.

 Overview Build UV Circuit 

This guide was first published on Sep 02, 2014. It was last updated on Sep 02, 2014.

This page (3D Print Enclosure) was last updated on Aug 20, 2014.

Text editor powered by tinymce.