The Adafruit FunHouse is the ideal companion to your Home Assistant setup. You can send not just the temperature, humidity, and barometric pressure using the onboard sensors, but you can also map the attached buttons, slider, and capacitive touch pads to control different parts of your home. You can also use the PIR Sensor to detect motion.

This guide explains how to configure your FunHouse to work with Home Assistant to send environmental data, trigger home automation events using the onboard sensors, and even use the embedded DotStars to emulate an RGB lightbulb that you can control with Home Assistant.

Parts Needed

Adafruit FunHouse - WiFi Home Automation Development Board
Home is where the heart's also where we keep all our electronic bits. So why not wire it up with sensors and actuators to turn our house into an electronic wonderland....
In Stock
Breadboard-friendly Mini PIR Motion Sensor with 3 Pin Header
PIR sensors are used to detect motion from pets/humanoids from about 5 meters away (possibly works on zombies, not guaranteed). This sensor is much smaller than most PIR modules, which...
In Stock
Mini Magnet Feet for RGB LED Matrices (Pack of 4)
Got a glorious RGB Matrix project you want to mount and display in your workspace or home? If you have one of the matrix panels listed below, you'll need a pack of these...
Out of Stock
USB Type A to Type C Cable - 1ft - 0.3 meter
As technology changes and adapts, so does Adafruit. This  USB Type A to Type C cable will help you with the transition to USB C, even if you're still...
In Stock

This guide was first published on Apr 22, 2021. It was last updated on 2021-04-22 09:11:16 -0400.

This page (Overview) was last updated on Apr 29, 2021.

Text editor powered by tinymce.