Solder a wire from USB VBUS to boost Vin (red wire). Solder a second wire from USB GND to boost GND (white wire).

Solder the 2x5 header to the perma-proto board. The first row should be on row 2; one row away from the mounting hole.

Solder a wire from the boost V+ to the top power (+) rail on the perma-proto (yellow wire). This will be the +12VDC rail.

Solder a wire from the boost GND to the top ground (-) rail on the perma-proto (white wire).

Solder a wire from the boost V- to the bottom power (+) rail on the perma-proto (green wire). This will be the -12VDC rail.

Solder a wire from the boost GND to the bottom ground (-) rail on the perma-proto (white wire).

Solder a small wire from the bottom negative power rail to the first row on the header (green wire).

Solder three small wires from the bottom ground rail to the second, third and fourth rows on the header (white wires).

Solder a short wire to connect pins 1 and 2 on the header to the negative voltage line (green wire).

Solder three small wires from the top ground rail to the second, third and fourth rows on the header (white wires).

Solder a small wire from the top positive power rail to the last row on the header (yellow wire).

Solder a short wire to connect pins 9 and 10 on the header to the positive voltage line (yellow wire).

Solder a wire from the EN pin on the boost to the closest row on the perma-proto (blue wire).

Solder a wire from the EN row to the other side of the perma-proto board (blue wire).

Solder a wire from the middle pin on the toggle switch to the EN row (blue wire). Solder a wire from the bottom pin on the toggle switch to the bottom GND row (white wire).

That completes the wiring!