Solder Headers

Solder the right-angle headers to the socket USB C breakout board, as shown in the photo.

Solder the included straight headers to the USB C Plug breakout board as shown in the photo.  

Jumper Ribbon

Peel 5 wires off the ribbon socket bundle. Plug connections into:

• GND
• VBUS
• CC1
• D- 
• D+

Mount USB C Socket Breakout

Use M2.5x5mm screws to mount the socket breakout board to the standoffs on the dock part.

Align USB C Plug Breakout and Connect

Place the Plug breakout board over the two vertical standoffs. 

Use two M2.5x5mm screws to mount the board. 

Match the jumper socket connections to the headers on the board.

Attach Case Cover

Align the cutouts on the case cover part over the USB C socket. 

Position the snap-fit parts on the case one side at a time.

Gently fold the ribbon cable into the case while press-fitting it over the USB C Plug.

Complete 

Use a USB C cable to connect to a device, such as your computer) or power source.

Plug a USB C dev board such as a Feather or QT Py in as shown and you're ready to go.