You can build a prop replica of Link’s Ultra Hand from The Legend of Zelda, Tears of the Kingdom.
We were inspired by Link’s new ability and used LED noodles to make it into a glowing 3D printed prop.
It’s a two piece wearable prop that fits over your arm and the palm of your hand.
The arm band has 3 LED noodles wired in series that are powered by a 9V battery while the palm uses a single LED noodle with a coin cell.
The battery holders feature switches that are easy to get to for quickly turning the LEDs on and off.
The LED noodles are pretty bright compared to EL wire and it’s even visible during the day.
This tiny coin cell battery holder is ideal for small portable or wearable projects. It holds one 20mm coin cell (also known as CR2032) in series to generate 3V nominal. 20mm coin...
$0.95
In Stock
Red and black tinned wires with a 2-pin JST PH connector on the end. 4" / 100mm long. Matches up nicely with our Lipoly chargers!
$0.75
In Stock
For a really long time we assumed that the JST PH didn't have a free-hanging male header version. But then we found this JST-PH 2-pin Male Cable, and we were...
$0.75
In Stock
This is a 9V battery pack with on/off switch and a pre-attached 5.5mm/2.1mm center-positive barrel plug. Use this to battery-power your Arduino (or other electronic projects) -...
$3.95
In Stock
Battery power for your portable project! These batteries are high quality at a good price and work fantastic with any of the kits or projects in the shop that use 9V.These...
$1.50
In Stock
A perfect match for our sew-able coin cell holder. This non-rechargeable coin cell is CR2032 sized: 20mm diameter, 3.2mm thick. It...
$0.95
In Stock
4 x
M2.5x6mm Screws
M2.5x6mm Screws
2 x
10Ω Resistor
10Ω Resistor
2 x
Elastic Rubber Band
Elastic Rubber Band
Page last edited May 10, 2024
Text editor powered by tinymce.
