You can build a prop replica of Link’s Ultra Hand from The Legend of Zelda, Tears of the Kingdom.

We were inspired by Link’s new ability and used LED noodles to make it into a glowing 3D printed prop.

It’s a two piece wearable prop that fits over your arm and the palm of your hand. 

The arm band has 3 LED noodles wired in series that are powered by a 9V battery while the palm uses a single LED noodle with a coin cell.

The battery holders feature switches that are easy to get to for quickly turning the LEDs on and off.

The LED noodles are pretty bright compared to EL wire and it’s even visible during the day.

Parts

4 x Blue 3V LED Noodle
nOOds - Flexible LED Filament - 3V 300mm long - Blue
Angled shot of a Single CR2032 / 20mm Coin Cell Battery Holder with Switch with a Cell Battery inserted.
This tiny coin cell battery holder is ideal for small portable or wearable projects. It holds one 20mm coin cell (also known as CR2032) in series to generate 3V nominal. 20mm coin...
$0.95
In Stock
Top view shot of a red and black JST PH 2-Pin Cable to Female Connector - 100mm.
Red and black tinned wires with a 2-pin JST PH connector on the end. 4" / 100mm long. Matches up nicely with our Lipoly chargers!
$0.75
In Stock
Top view shot of JST PH 2-Pin Cable - Male Header - 200mm.
For a really long time we assumed that the JST PH didn't have a free-hanging male header version. But then we found this JST-PH 2-pin Male Cable, and we were...
$0.75
In Stock
Angled shot of black 9V battery holder with on-off switch and 5.5mm/2.1mm plug.
This is a 9V battery pack with on/off switch and a pre-attached 5.5mm/2.1mm center-positive barrel plug. Use this to battery-power your Arduino (or other electronic projects) -...
Out of Stock
Angle shot of PKcell 9V battery.
Battery power for your portable project! These batteries are high quality at a good price and work fantastic with any of the kits or projects in the shop that use 9V.These...
$1.50
In Stock
Front shot of CR2032 Lithium Coin Cell Battery upright.
A perfect match for our sew-able coin cell holder. This non-rechargeable coin cell is CR2032 sized: 20mm diameter, 3.2mm thick. It...
Out of Stock
4 x M2.5x6mm Screws
M2.5x6mm Screws
2 x 10Ω Resistor
10Ω Resistor
2 x Elastic Rubber Band
Elastic Rubber Band

This guide was first published on Jun 13, 2023. It was last updated on May 10, 2024.

This page (Overview) was last updated on May 10, 2024.

Text editor powered by tinymce.