This project demonstrates a way to add another layer of distance between two people messaging on Signal. It sends messages encrypted with AES but it doesn't include who the sender or receiver are.

Shot timers are great tools for anyone trying to progress their shooting skills. Unfortunately, they're super expensive! That's where this project comes in. In this project, you will create an open-source shot timer using the Adafruit Clue board. It will have a GUI with a full menu, multiple modes, and persistent settings.

This guide will explore how to read your board's battery level, code-free, with Adafruit IO WipperSnapper. It will also explore how to send an SMS alert when your battery is fully charged.

This guide will explore how to generate tones with a piezo buzzer code-free with Adafruit IO WipperSnapper.

Learn how to connect a DS18B20 one-wire temperature sensor to a microcontroller and control it code-free with WipperSnapper!

This project is perfect for the book lover in all of us. In this project you will create a clock that tells the time using quotes from books. It'll update every five or so minutes (there are enough quotes to update more often but doing so has the potential to wear out your eInk display) each time displaying a quote that has the time highlighted in bold.

Do you have trouble waking up? Do you keep forgetting to get in bed at a decent time? Are you impressively bad at remembering to take medications? Do you have multiple stuffed sharks and no idea what to do with them? If any (or all) of these seem relatable then this project is for you!

In this guide, you'll learn how to set up your PB Gherkin 30% keyboard to use KMK firmware. You'll use the PB Gherkin, designed by 40percent.club, and the new Adafruit KB2040, to build a keyboard that you'll put KMK firmware on and learn how to remap it and create your own configuration.

In this guide, you'll learn how to set up your May Pad macropad to use KMK firmware. You'll use the May Pad, designed by /u/reggatronics, and the new Adafruit KB2040, to build a macropad that you'll put KMK firmware on and will also learn how to remap it and create your own configuration.

In this guide, you'll learn how to set up your Navi10 macropad to use KMK firmware. You'll use the Navi10, designed by /u/emdarcher, to build a macropad that you'll put KMK firmware on and will also learn how to remap it and create your own configuration.

In this guide you'll learn how to use a MagTag or a CLUE, or both if you're feeling daring, to create a pep talk generator that will randomly create a motivational sentence using 4 phrases.  

October is open-source month. What better way to celebrate it than by using open-source hardware and software to celebrate all of the amazing open-source hardware that's been certified by OSHWA over the last few years!

In this project, you'll connect to an electronically controlled surge protector with a built-in relay. You'll connect an Adafruit FunHouse to Adafruit IO WipperSnapper and then be able to control the device over the internet. All without code.

Learn how to use the new Adafruit IO WipperSnapper to make a door alarm without any code! WipperSnapper is a really easy way to set up your device to interface with loads of sensors and devices and send it to Adafruit IO.

Learn how to use the Adafruit IO WipperSnapper to read inputs from push buttons!