Headers for PropMaker FeatherWing

Use a 12-pin and 16-pin male header pins for the PropMaker FeatherWing.

The strips of header are installed from the bottom of the PCB.

Breadboard for Headers

Using a breadboard can help keep the headers straight while soldering. Apply solder to all of the pins.

Headers for Feather M4

Use a 12-pin and 16-pin female headers for the Feather M4. The headers are installed on the top of the PCB.

Installing Feather Headers

Use the male headers from the PropMaker FeatherWing to help install the headers for the Feather M4.

Install the 12-pin and 16-pin female headers over the PropMaker's male header pins.

Place the Feather M4 over the pins on the female headers.

Solder Headers to Feather M4

Use a PCB vise to keep the PCB sturdy while soldering. Apply solder to all of the pins on the Feather M4.

Installed Headers

Pull apart the Feather M4 and PropMaker FeatherWing. These will be kept separated until the end of the assembly.

This guide was first published on Oct 27, 2021. It was last updated on 2021-10-27 08:11:13 -0400.

This page (Headers) was last updated on Nov 11, 2021.

Text editor powered by tinymce.