Circuit Diagram

Follow the circuit diagram to reference how the components will be connected together. The size of the components and length of wires are not exact - This diagram is meant to be used as a point of reference.

Wire Connections

Slide switch is wired to the EN and GND pins on the Powerboost 500C.

The positive pin from the powerboost is wired to GPIO #2 on the 3.5" PiTFT display. Negative pin is wired to GPIO #6.

The male JST from the 2500mAh battery is connected to the JST connector on the Powerboost500C.

The 3.5" PiTFT display connects to the GPIO header on the Raspberry Pi Model A+.

This guide was first published on Jan 26, 2015. It was last updated on Jan 26, 2015.

This page (Circuit Diagram) was last updated on Jan 19, 2015.

Text editor powered by tinymce.