This project uses the accelerometer on the Circuit Playground Express board to control the X and Y axes of a maze. The user can guide a marble through the maze by simply tilting the Circuit Playground Express. This project is constructed using only cardboard, hot glue, and a couple of screws.

Circuit Playground Express is the next step towards a perfect introduction to electronics and programming. We've taken the original Circuit Playground Classic and...
guides with product
Out of Stock

Tiny little servo can rotate approximately 180 degrees (90 in each direction) and works just like the standard kinds you're used to but smaller. You can use any servo...
$5.95
In Stock

When working with unusual non-header-friendly surfaces, these handy cables will be your best friends! No longer will you have long, cumbersome strands of alligator clips. These...
guides with product
$3.95
In Stock

This here is your standard A to micro-B USB cable, for USB 1.1 or 2.0. Perfect for connecting a PC to your Metro, Feather, Raspberry Pi or other dev-board or...
$2.95
In Stock
Materials
In addition to the electronics, for this project you will also need:
- Marble or steel ball
- Scrap cardboard
- Hot glue gun
- Scissors or hobby knife
- Small magnet
Page last edited March 08, 2024
Text editor powered by tinymce.