TFT FeatherWing

Save Subscribe

Install HUZZAH32 to TFT FeatherWing

The Adafruit Feather snap onto the back of the TFT FeatherWing with the header pins inserting into the female headers.

Flush Headers

If the header pins are visible they may need to be trimmed short. The plastic housing of the male headers ought to be flush with the female headers. Use a pair of flush diagonal cutters to trim the header pins short. 

Be careful not to trim the header pins too short! About half their total length is suffice.

Connect Wires from AMG8833

Now you can plug in the male header pins from the thermal camera sensor to the spare headers on the back of the TFT FeatherWing. You can also trim the header pins short to fully seat them flush with the female headers.

 AMG8833 Assembly 

This guide was first published on Jan 17, 2018. It was last updated on Jan 17, 2018.

This page (TFT FeatherWing) was last updated on Jan 12, 2018.

Text editor powered by tinymce.