Ext. Mic Assembly

Save Subscribe
If you have an EDGEBADGE with built in mic OR your PyBadge kit came already with a microphone and cable kit, you can skip this step!

Step 1 - Solder Headers onto Microphone

You'll need to plug into your microphone, so visit this guide for step by step instructions on soldering the headers on

adafruit_products_sensors_2013_01_12_IMG_1160-1024.jpg

Step 2 - Connect JST PH Cable to Microphone

Connect Red to VCC, Black to GND and White to OUT

adafruit_products_IMG_2128.jpg

Step 3 - Cut and solder the 3V selection jumper on the back of the PyBadge or PyGamer

On the back of your board, find the STEMMA cable voltage selection jumper. Cut the trace from Vcc to 5V

Then solder in the Vcc to 3V pads

Step 4 - Plug in Microphone into D2

adafruit_products_IMG_2131.jpg
 Micro Speech Demo Troubleshooting 

This guide was first published on Jul 23, 2019. It was last updated on Jul 23, 2019.

This page (Ext. Mic Assembly) was last updated on Nov 22, 2021.

Text editor powered by tinymce.