Slide Switch Wire
Use the silicone ribbon cable to create a 2-pin cable. Measure and cut the wire to be 7.5cm in length.
Wiring Slide Switch
Cut one of the three pins on the slide switch, either the far left or right but not the middle. The, cut the two remaining pins to half their length.
Solder the 2-pin cable to the pins on the slide switch.
Connected Slide Switch
The two wires are soldered to the pins on the bottom of the Feather.
Solder one wire to the ground pin (G) and the other to the enable pin (EN). It doesn't matter which wire goes to which pin.
Soldered Slide Switch
Double check the wires have been properly soldered to the pins on the RP2040 PropMaker Feather.
Speaker Wires
Cut the cable from the speaker so the wires are 8cm in length.
Remove a bit of insulation from the two wires and tin them using a bit of solder.
Optionally save the 2-pin connector for another project.
Battery Monitoring (optional)
This die has the optional 100K resistors installed for battery monitoring. These can reach point-to-point across the board, using some heat-shrink tube to prevent making contact with other components as the die bounces about. One pin of the servo header is borrowed as a ground point.
Text editor powered by tinymce.
