Solder Cable to Speaker

A 2-pin JST cable is used to extend the cable from the mini oval speaker. Clip the original mini connector off the end of the speaker wires and aim for the following wire lengths:

2-pin JST plug cable length: 2 inches

Speaker cable length: 3 inches

If your speaker cable was clipped shorter than this, you can compensate on the JST cable side, for a total of 5 inches.

Put some heat-shrink tubing over the JST wires before soldering to the speaker wires. Once the connections are soldered, slide the heat-shrink over the exposed part of the wires and apply heat.

Wired Speaker

Double check the cable from the speaker has been properly soldered and the connections are not exposed.

This guide was first published on Nov 09, 2021. It was last updated on Mar 27, 2024.

This page (Wiring Speaker) was last updated on Mar 08, 2024.

Text editor powered by tinymce.