Wire for Slide Switch

The slide switch uses a 2-wire ribbon cable (or 2 separate wires) that will be soldered directly to the pins on the Adafruit Feather M4.

Wire length: 4 inches.

One wire goes to the center pin on the switch, the other goes to either one of the outer two pins. The opposite outer pin is not used and can be trimmed shorter if you like.

Wired Slide Switch

Double check the 2-wire ribbon cable is properly soldered to the pins on the slide switch.

This guide was first published on Nov 09, 2021. It was last updated on 2021-11-09 20:43:12 -0500.

This page (Wiring Slide Switch) was last updated on Nov 09, 2021.

Text editor powered by tinymce.