Wires for Push Button

The push button is wired to a 2-pin JST cable to make the assembly much easier.

Wire Lengths: 6 inches.

Solder Cable to Push Button

Attach the two wires from the cable to the pins on the push button. Polarity does not matter. The wires are soldered to the pins at a right angle to make assembly easier.

Wired Push Button

Double check the wires are properly soldered to the two pins on the push button.

This guide was first published on Nov 09, 2021. It was last updated on Mar 28, 2024.

This page (Wiring Push Button) was last updated on Mar 08, 2024.

Text editor powered by tinymce.