Controller Assembly
Solder a 3" (7.6 cm) solid core wire into the ANT pin on the Feather. Solder male headers onto the bottom of the Feather. If you need more instructions for soldering headers, check out this How to Solder Headers Guide.
With antennas length matters! So make sure to measure out the 3" (7.6 cm) section of wire precisely.
Solder a wire to each of the two legs of your on/off switch and cover with heat shrink. Tin the other end of the wires carefully, and insert them into the outer row of header sockets on the back of the TFT screen. One wire should go EN (the second pin from the right on the bottom row) and the other to G. Any G pin will work - I used the far left socket on the top row. Make sure they're in there tightly and won't fall out easily.
Plug the Feather in to the back of the TFT screen as shown, using the inner ring of female header sockets with the USB port facing to the right.
Plug the Gamepad into the Feather using the STEMMA QT cable, and plug the LiPo battery into the battery JST port on the Feather. Be sure the EN on/off switch on the TFT screen is flipped to ON.
Click your on/off switch and the controller should power up. Leave the TFT screen switch in the ON position. It'll be buried inside the case and hard to access later on.
Page last edited October 07, 2026