Getting the Sound Files
Click the green button below to download the sound files used for this project. In the folder you download the file to, use your file explorer/finder to open the zip file and extract the 7 sound files which all have the .ogg file extension.
Loading the Sounds
Plug the FX sound board into your computer via a known, good data USB cable. Your computer should indicate a new removable drive was attached. Using your file explorer/finder, copy the 7 sound files from your downloads area onto the removable drive.
See this guide for details on copying over the sound files.
Eject the drive and unplug from USB. Now you can complete the wiring.
Connect the Feather Board to the FX Sound Board.
- Pin 13 -> 0
- Pin 12 -> 1
- Pin 11 -> 2
- Pin 10 -> 3
- Pin 9 -> Act
- GND -> Gnd
- 3V -> Vin
Connect the Amplifier to the audio output of the FX Sound Board.
- L -> A+
- Gnd -> A-
- Vin -> Vin
- Gnd -> Gnd
Connect the Amplifier to the audio output of the FX Sound Board.
- L -> A+
- Gnd -> A-
- Vin -> Vin
- Gnd -> Gnd
Connect the speaker wires to the + and - sides of the Amplifier.
This is what the final electronics looks like. Load in the code that runs it all on the next page.
