First we will solder two header pins to the Feather board. One gets attached to 3V and the other to GND. This will help to mount the Accelerometer later.

Now add a switch with one end connected to the En and the other end to GND. This will let you turn the glove off but still charge the battery.

Connect a button from Pin 5 to GND. This will act as a mode button.

I like to feed some of this wires through the mounting holes to take the stress off of the solder joints.

This guide was first published on Jun 05, 2019. It was last updated on Jun 05, 2019.

This page (First Steps) was last updated on Sep 04, 2016.

Text editor powered by tinymce.