Use the instructions on this page if you would like to use the Ikea wooden lazy susan top. If you would like to use the 3D printed top, skip to the next page.
Install Gear & Susan
Place the 3D printed internal gear over the center of the wooden tabletop with the three mounting holes lined up.
Place the Lazy Susan swivel plate with the bolt over the 3D printed internal gear with the mounting holes lined up.
Secure Susan
Insert and fasten the three wood screws through the mounting holes to secure the three parts together.
Install Susan Mount
Place the Lazy Susan Mount over the swivel plate with the bolt going through the center hole.
Insert the hex nut onto the thread of the bolt.
Secure Susan Mount
Use a 13mm metric socket to fasten the nut to the bolt. The Lazy Susan mount should spin freely.
Align Mount and Bottom Plate
Begin joining the Susan Mount to the bottom plate.
Orient the Susan mount with the stepper motor so the side with the large opening allows the parts to fit together.
The various wires should pass through the wall openings in the Susan mount.
Secure Susan Mount to Bottom Plate
Turn over the tabletop so the bottom plate is facing up.
Position the bottom plate so the four corresponding mounting holes are lined up with the mounting holes on the Susan mount.
Insert and fasten four M3 x 6mm long machine screws to secure the Susan mount to the bottom plate.
Install Knob
Line up the 3D printed knob with the shaft of the rotary encoder.
Press the 3D printed knob into the shaft of the rotary encoder.
Plug the power supply to the DC jack on the back of the turntable.
Page last edited January 27, 2025
Text editor powered by tinymce.