3D Printed Top Assembly
Orient the 3D printed tabletop with the three standoffs facing up.
Place the internal gear over the tabletop with the three mounting holes lined up.
Secure Lazy Susan
Place the Lazy Susan swivel plate over the internal gear with the mounting holes lined up.
Use three M5 x 6mm long machine screws to secure the swivel plate to the internal gear and tabletop.
Secure Lazy Susan Mount
Place the Susan mount over the swivel plate with the bolt going through the center hole.
Use a 13mm metric socket to secure the nut to the bolt.
The Susan mount is spin freely.
Align Susan Mount and Bottom Plate
Begin joining the Susan Mount to the bottom plate.
Orient the Susan mount with the stepper motor so the side with the large opening allows the parts to fit together.
The various wires should pass through the wall openings in the Susan mount.
Secure Susan Mount to Bottom Plate
Turn over the tabletop so the bottom plate is facing up.
Position the bottom plate so the four corresponding mounting holes are lined up with the mounting holes on the Susan mount.
Insert and fasten four M3 x 6mm long machine screws to secure the Susan mount to the bottom plate.
Install Knob
Line up the 3D printed knob with the shaft of the rotary encoder.
Press the 3D printed knob into the shaft of the rotary encoder.
Plug the power supply to the DC jack on the back of the turntable.
Page last edited January 27, 2025
Text editor powered by tinymce.