Hardware

Use the following hardware to secure the Feather to the 3D printed stand.

• 4x M2.5 x 6mm long screws
• 2x M2.5 x 10mm long female-female standoffs
• 4x M2 x 6mm long screws
• 2x M2 x 10mm long female-female standoffs

Install M2 Hardware

Insert an M2 x 6mm long screw through the smaller mounting hole on the TFT side of the PCB.

Then, fasten an M2 x 10mm long standoff onto the thread of the screw.

Installed M2 Standoffs

Repeat the process for the second smaller hole. The standoffs should sit flush with the edge of the ESP32 chip.

Install M2.5 Hardware

Instal an M2.5 x 6mm long screw through the larger sized holes on the TFT side of the PCB.

Then, fasten an M2.5 x 10mm long standoff onto the thread of the screw.

Installed M2.5 Standoffs

Repeat the process for the second hole. The standoffs should sit flush with the edge of the SMD LEDs.

Installed Hardware

Double check the standoffs have been properly secured to the Feather's mounting holes.

Secure M2.5 Hardware

Place the Feather onto the 3D printed stand with the mounting holes lined up with the standoffs.

Insert and fasten the remaining M2.5 screws to secure the M2.5 standoffs. 

Secure M2 Hardware

Repeat the process to secure the M2 standoffs to the 3D printed stand.

Secured Feather

Use the opening on the back of the 3D printed stand to access the various ports.

USB Power

Connect the Feather with a USB-C cable and power using 5V power supply or computer hub.