Assemble lamp shade

Lay the diffuser with the channels facing up.

Align the corner of each panel to the corner of the channel.

Insert each panel at a 15 degree angle to press fit each panel into the diffuser.

Cable tube

Place M3 nuts into the "cable-tube" part. 

Align the screws holes to the three matching screws mounts on the "case-btm" part.

Use M3x6mm screws to combine the parts.

Mount Circuit Playground

Place the Circuit Playground with the USB port aligned to the cutout on the "case-btm" part.

Align the "Case-top" part to the microphone and light meter cutouts.

The board is mounted to the "case-btm" part with M3x6mm screws.

Attach shade

Pre-fasten M2x6mm screws to the panels.

Align each screw to the screw mounts on the sides of the "case-btm" part.

USB Cable

Plug the USB cable into the port.

Route the cable into the cutout on the "cable-tube" part.

Pass the USB cable through cutout on the "tube-coupler".

Align the screw holes on both parts and use an M3x5mm screw to join the coupler to the "cable-tube" part.

Thread pipes and base

Twist the threads on the pipes and base together until the channels all align.

Link chain

Combine the chain links by passing them through the center cuts.

Press fit the USB cable into the pipe channel down to the base.