This 4-wire cable is a little over 400mm / 15.7" long and fitted with JST-SH female 4-pin connectors on both ends. Compared with the chunkier JST-PH these are 1mm pitch instead of 2mm, but still have a nice latching feel, while being easy to insert and remove.

It's a GPIO expander, it's a keypad matrix driver... its the Adafruit TCA8418 Keypad Matrix and GPIO Expander Breakout - a cute and powerful I2C GPIO expander and keypad matrix driver! This chip is quite fancy, with the ability to act as your I2C...

For folks who want ready-to-go keeb action, we've got the lovely Adafruit Macropad with a 3x4 grid of MX+NeoPixel key switches - but for those who like to forge their own path, we now present the easiest way of creating custom ortholinear...

For crafting your very own custom keyboard, these Kailh Black Linear mechanical key switches are deeee-luxe! With smooth actuation and Cherry MX compatibility, they're lovely when you want a smooth linear keystroke with a...

Dress up your mechanical keys in your favorite colors, with a wide selection of stylish DSA key caps. Here is a 10 pack of blue DSA keycaps for your next mechanical keyboard or NeoKey project. Snap 'em onto...

Dress up your mechanical keys in your favorite colors, with a wide selection of stylish DSA key caps. Here is a 10 pack of dark blue DSA keycaps for your next mechanical keyboard or NeoKey project. Snap 'em onto...

Dress up your mechanical keys in your favorite colors with a wide selection of gumdrop-like, retro, curvy, and stylish MA profile keycaps. Here is a 5 pack of Cyan MA Keycaps for your next mechanical keyboard or 

Wanna improve the connection strength between your project's 3D-printed parts, and also have nice clean surfaces? Instead of gluing bits together, or screwing plastic screws directly into your 3D prints, use strong and reusable machine screws and heat-set inserts. Heat set inserts are only...

Totaling 420 pieces, this M3 Screw Set is a must-have for your workstation. You'll have enough screws, nuts, and hex standoffs to fuel your maker tendencies for days on end! M3 size screws fit a number of Adafruit breakout/dev board...

Totaling 380 pieces, this M2.5 Screw Set is a must-have for your workstation. You'll have enough screws, nuts, and hex standoffs to fuel your maker tendencies for days on end! M2.5 size screws fit almost all of the Adafruit breakout/dev board mounting holes...

Keep your electronics from going barefoot, give them little rubber feet! These small sticky bumpers are our favorite accessory for any electronic kit or device. They are sticky, but not impossible to remove. They're small enough to fit onto any board, and have just enough height to give...