Overview

Build a paper craft hack a day logo, powered by a Circuit Playground Express!

 

This project is a great use of our customizable paper enclosure for the Circuit Playground. We'll use alligator clips for all of the connections so it requires no soldering! Perfect for workshops and class room settings!

 

The two buttons on the Circuit Playground control the direction of the spinning wrenches but you can easy modify the code to respond to any of the on board sensors! 

circuit_playground_parts.jpg

circuit_playground_servo-parts.jpg

1 x .8mm Chipboard
.8mm Chipboard
1 x 1.6mm Chipboard
1.6mm Chipboard

Circuit Playground Express

PRODUCT ID: 3333
Circuit Playground Express is the next step towards a perfect introduction to electronics and programming. We've taken the original Circuit Playground Classic and...
$24.95
OUT OF STOCK

Circuit Playground Bolt-On Kit

PRODUCT ID: 3816
You have a Circuit Playground Express, but you need to mount it to your charming cardboard robot friend, eh? Not so easy if you...
$0.00
IN STOCK

Small Alligator Clip to Male Jumper Wire Bundle - 12 Pieces

PRODUCT ID: 3255
For bread-boarding with unusual non-header-friendly surfaces, these cables will be your best friends! No longer will you have long strands of alligator clips that are grabbing little...
$7.95
OUT OF STOCK

Continuous Rotation Micro Servo

PRODUCT ID: 2442
Need to make a tiny robot? This little micro servo rotates 360 degrees fully forward or backwards, instead of moving to a single position. You can use any servo code, hardware...
$7.50
OUT OF STOCK

3 x AAA Battery Holder with On/Off Switch and 2-Pin JST

PRODUCT ID: 727
This battery holder connects 3 AAA batteries together in series for powering all kinds of projects. We spec'd these out because the box is slim, and 3 AAA's add up to about...
$1.95
IN STOCK
Last updated on May 29, 2018 Published on May 29, 2018