First, download the image of Sparky by clicking on the green box below. Print out two copies. We'll use the second copy to create his mouth.

Next, you'll need some pieces of cardboard, scissors, and a glue stick.

For best results, add glue to both the paper and the cardboard. 

 

Place Sparky on cardboard base. Press these two together firmly, smoothing out any creases. 

 

Cut out Sparky's teeth from second printout. Glue this jaw to a small piece of cardboard.

It can be helpful to place Sparky under a very heavy book (or multiple smaller books, etc.) while the glue dries. 

After waiting for about 10-15 minutes for the glue to dry, you're ready to start cutting the outline!

Cut out Sparky's blue-flame outline.

 

Cut around the outline of the jaw.

 

Outline a slot on Sparky's chin through which the jaw will be attached.

 

Cut out the slot in Sparky's chin carefully with points of scissors or an X-acto blade.

This guide was first published on Jun 21, 2018. It was last updated on Jun 21, 2018.
This page (Create Sparky) was last updated on Oct 21, 2020.