This is a remix of the 3d Printed Circuit Playground Yo Yo project by the Ruiz Brothers.  

There are 5 different pieces to print:  the base, the top, the buttons, the cover, and the belt clip.

If you don't have access to a 3d printer, you can order the whole case ready-to-go from Shapeways.

Slice Settings

Below are some recommended slice settings. These parts were printed on an Up! Mini.

• .15mm layer height
• 220C extruder / PrintInZ Skin
• 20% infill
• 4 top/bottom layers
• 2 shells / parameters
• 40mm/s printing speed