Handles for Case
Get the two handles ready to secure to the side of the case.
Line up the mounting holes on the handle with the holes on the side of the case.
Secure Handles to Case
Hold the handle in place while inserting and fastening the M2.5 x 6mm long steel machine screws.
Repeat the installation with the second handle.
Speaker Grill for Case
Get the speaker grill ready to secure to the side of the case.
Place the speaker grill into the case with the mounting holes lined up.
Secure Speaker Grill
Insert and fasten the M3 x 6mm long screws to attach the speaker grill to the case.
Use the M3 hex nuts to secure the speaker grill in place.
Speaker Mount
Gather up the speaker, hardware and 3D printed speaker mount.
Place the 3D printed speaker mount over the enclosed speaker with the mounting holes lined up.
Secure Speaker to Mount
Use the M3 x 10mm long steel machine screws to attach the 3D printed mount to the enclosed speaker.
Use the M3 hex nuts to secure the speaker to the mount.
Battery Mount
Get the bottom case cover, battery mount, and hardware ready.
Place the battery mount over the bottom case cover with the mounting holes lined up.
Secure Battery Mount
Insert and fasten the M3 x 6mm long steel machine screws to secure the battery mount to the bottom cover.
Secure Speaker Mount
Place the speaker mount on top of the bottom cover with the mounting holes lined up.
Insert and fasten the M3 x 10mm long steel machine screws to attach the speaker mount to the bottom cover.
Use the M3 hex nuts to secure the parts together.
Hardware for Switch Holder
Get the slide switch holder and hardware ready to install onto the bottom cover.
Secure Switch Holder to Bottom Cover
Insert and fasten the M3 x 6mm long screws to attach the slide switch holder to the bottom cover.
Use the M3 hex nuts to secure the parts together.
Feather Connections
Get the wires from the various electronics ready to connect to the PropMaker Feather RP2040.
Connect Speaker
Insert the two wires from the speaker into the corresponding pins on the Feather screw-block terminals.
Use a flat head screwdriver to secure the wires.
Connect NeoPixel Strip
Insert the three wires from the NeoPixel strip into the corresponding pins on the Feather screw-block terminals.
Use a flat head screwdriver to secure the wires.
Connect Button Switch
Insert the two wires from the quick-connect cable into the corresponding pins on the Feather screw-block terminals.
Use a flat head screwdriver to secure the wires.
Install Feather to Bottom Cover
Place the PropMaker Feather RP2040 onto the two standoffs on the bottom cover.
Secure Feather
Use the M2.5 x 6mm long steel machine screws to secure the Feather to the bottom cover.
Install Battery Clip
Slide the battery into the 3D printed battery holder so it fits flush.
Fit the 3D printed battery clip over the battery so it snap fits onto the holder.
Connect Button Wires
Plug in the two wires from the quick-connect cable onto the arcade buttons micro switch.
Test Circuit
Use the slide switch to power on the PropMaker Feather RP2040.
Check the battery's built-in on/off switch is to the "ON" position.
Press the arcade button to play sound and light up the NeoPixels.
Install Top to Case
Orient the top with the case so they can be fitted together.
Snap fit the top cover onto the 3D printed case.
Install Bottom to Case
Orient the bottom cover with the 3D printed case so the Feathers USB-C port is lined up with the cutout.
Page last edited June 11, 2024
Text editor powered by tinymce.
