Solder Dispenser

In this project, we'll design and 3D print a custom enclosure for storing and dispensing solder. This cute little enclosure looks like Adabot and can be used as a solder dispenser or tape dispenser. There's plenty of room in the enclosure to store two spools of solder or several rolls of small tape.

The spools can rotate independently, allowing you to have different solder spools sizes to quickly swap between different diameters.   

Parts

You only need a couple parts to complete this build:

If you want to make a kit you'll need some solder. This 1/4 lb (about 110 gram) spool is just the right amount, not too much (like 1 lb spools) and not too little (like those...
Out of Stock
If you want to make a kit you'll need some solder. This 0.1 lb / 50 gram spool is a good amount, not too much (like 1 lb spools) and not too little (like those little 'pocket...
$14.95
In Stock
OK yes, it's just masking tape. A big honkin' roll of I'm blue da-ba-dee-da-ba-die masking tape.Removing 3D printed parts can be tough. Sometimes pieces get stuck to...
Out of Stock
These Italian-made Hakko pliers are excellent for any precision work. The nose is flattened and fairly short to provide excellent control. The inside of the jaws is also flattened so...
$11.95
In Stock
Having a 3D printer without filament is sort of like having a regular printer without paper or ink.  And while a lot of printers come with some filament there's a good chance...
Out of Stock
The Flashforge Creator Pro is the latest addition to FlashForge’s Creator family, built upon an open source platform.Based on proven design of the Creator...
Out of Stock

This guide was first published on Jan 04, 2017. It was last updated on Jan 04, 2017.

This page (Overview) was last updated on Apr 12, 2021.

Text editor powered by tinymce.