The wires need to be disconnected from the 1200mAh LiPo so they can be extended during assembly.
First we need to peel back the Kapton tape protecting the PCB and the solder pads.
Using a pair of sharp small scissors make two cuts at the outer edge of each solder pad.
Hold the tape clear of the solder pads and using a good quality Soldering Iron remove the two wires from the LiPo

This guide was first published on Mar 06, 2014. It was last updated on Mar 06, 2014.

This page (Preparing the LiPo Battery) was last updated on Nov 27, 2021.

Text editor powered by tinymce.