Fit an M3 45mm Screw into each of the corners and lay the assembly face down.
Bend the Camera's FFC as shown in the photo.
Solder extensions onto the two power leads. Insulate the joins with heat-shrink.
Place two M3 x 4mm Nylon Spacers over the two M2.5 Brass Inserts.
Fit the Raspberry Pi Model A. Secure it with two M2.5 Nylon Screws.
Do not over-tighten the Nylon screws as doing so could strip the threads.
Be careful not to trap either the Camera's FFC or any of the power cables when fitting the Raspberry Pi.
Fit the previously glue U-Section, and the glued corner to the assembly.

This guide was first published on Mar 06, 2014. It was last updated on Apr 24, 2014.

This page (Part Three) was last updated on Mar 05, 2014.

Text editor powered by tinymce.