Toggle Switch Wiring
Use two silicon cover wires to connect the toggle switch to the TFT FeatherWing.
Measure and cut two 9cm long wires.
Solder the wires to the the middle and either far left or right pins on the toggle switch.
Slide Switch Wiring
Use two silicon cover wires to connect the slide switch to the TFT FeatherWing.
Measure and cut two 11cm long wires.
Solder the wires to the the middle and either far left or right pins on the toggle switch.
Button Wiring
Use two silicon cover wires to connect the button to the TFT FeatherWing.
Measure and cut two 9cm long wires.
Solder the wires to the the middle and either far left or right pins on the toggle switch.
Potentiometers Wiring
Use a set of three wires for each potentiometer.
Measure and cut 9cm long wires.
Potentiometer Common Ground
Solder two black colored wires to either the far left or right pin on one of the potentiometers.
Solder a yellow colored wire to the middle pin.
Solder a red wire to the remaining pin.
Soldering Potentiometer
Solder the black wire from the other potentiometer to either the far left or right pin.
Solder a green wire to the middle pin.
Solder a red wire to the remaining pin.
Wired Potentiometers
Double check all of the pins on the potentiometers have been correctly soldered.
Page last edited March 08, 2024
Text editor powered by tinymce.