USB Solder Fume Exactor
This uses a 5VDC fan and it’s wired up to a USB connector so we can plug it into a USB battery. The 3D printed enclosure snap fits and allows for easy carbon filter replacements.
Small and Cute!
The fan is only 50x50mm so it doesn’t take much space on your work surface. Just plug it into any 5V USB rechargeable battery. Keep the air clean, fume-free and save space on your work bench!
Features a GoPro style hinge so you can adjust the angle of the fan. It’s compatible with GoPro style adapters so it can be set up on a tripod or even a magic arm.
PRODUCT ID: 3836
If you do a lot of soldering indoors, a Carbon Filter is essential for absorbing that solder smoke and leaving your air smelling fresh.These measure about...
PRODUCT ID: 1387
Make your own USB connections without slicing apart a USB cable and soldering those thin wires inside. These DIY "USB shells" are available in
PRODUCT ID: 1827
Make your own USB connections without slicing apart a USB cable and soldering those thin wires inside. This is the 'slim' version of the DIY USB-A Male connector. It's a...
PRODUCT ID: 3890
For those who are fans of our silicone-covered wires, but are always looking to up their wiring game. We now have Silicone Cover Ribbon cables! These may look...
PRODUCT ID: 1959
A smaller-sized rechargeable battery pack for your Raspberry Pi or Raspberry...
This guide was first published on May 27, 2020. It was last updated on May 27, 2020.
This page (Overview) was last updated on Aug 08, 2020.