FDM 3D Printing
These parts are optimized to print with desktop 3D Printers capable of printing in ABS or PLA material with a minimum build area of 100mm x 100mm x 90mm. The two parts are designed to print without any support material or raft.
Printing Tiny Buttons
The buttons are rather small and should be printed separately. These can be painted or printed in different colored filament. We recommend printing these pieces with slow feed and travel rates (about 45/50mms).
|
cloudcase.stl cloudcover.stl cloudABbtn.stl cloudDiabtn.stl cloudSelbtn.stl |
235c 10% infill 90 feed 120 travel no supports or rafts |
Printing all five parts should take about one hour to print. |
Slicing Software
The recommend settings above should work with most slicing software. However, you are encouraged to use your own settings since 3D printers and slicing software will vary from printer to printer.
PLA or ABS Material
We recommend using PLA material for an easier print with high quality. The tolerance has been tested with PLA filament, but should also work with ABS. The parts do not require any support material or a raft.
Page last edited October 13, 2014
Text editor powered by tinymce.
