The breakout can be used via the 3-pin JST-PH connector, or the 3 pin breadboard header.

JST-PH Connector

On the front of the board is the JST-PH connector with the three pins for providing power and a signal from the DRV5032 Digital Hall Sensor.

• GND - The left input on the JST-PH connector is common ground shared between the two CAN connections.
• VIN - It is connected to the middle pin on the JST-PH connector. This has to be a DC voltage 1.65V to 5.5V.
• OUT - the DRV5032 output signal pin changes between HIGH and LOW depending on the presence of a magnetic field. It is connected to the right input on the JST-PH connector.