If you're using your RunCPM emulator with the 5" Display Backpack, there's a 3D printable bracket you can mount everything to.
Print the bracket on its side, as shown. Use a layer height of 0.2mm to 0.3mm. On most printers, no support is required. PLA and PETG are very suitable for this print. Use the download button below to grab the 3D printable STL file as well as the FreeCad design file:
From the M2.5 mounting hardware box, pick out:
- 16 of the M2.5 x 4mm Screws (the shortest screw)
- 8 of the 6mm long F-F hex standoffs (the shortest standoff)
Begin by installing the stand-offs:
- The outermost 4 holes are for the display. At each position, insert a screw from the back and tighten a stand-off on the front.
- The remaining holes support a number of different boards & configurations. Find the inner columns of 6 holes each and place stand-offs on the back in the first and last positions, fastening from the front with screws.
Next, attach the display on the front with the connectors on the right and hand-tighten the 4 screws on the front.
Finally, remove the boards from the feather tripler and attach the Feather tripler on the back side of the bracket, orienting it so that the DVI connector will be on the same edge as the display. Counting from the bottom of the tripler, screw in the first and fourth sets of holes into the standoffs.
Re-install the Feathers and FeatherWing, connect the display, keyboard and power. Then power on!
Text editor powered by tinymce.
