Angled shot of Raspberry Pi 4
The Raspberry Pi 4 Model B is the newest Raspberry Pi computer made, and the Pi Foundation knows you can always make a good thing better! And what could make the Pi 4 better...
Out of Stock
Angled shot of Adafruit DC & Stepper Motor HAT.
Let your robotic dreams come true with the new DC+Stepper Motor HAT from Adafruit. This Raspberry Pi add-on is perfect for any motion project as it can drive up to 4 DC or 2 Stepper...
guides with product
$22.50
In Stock
Angled shot of blue, square-shaped, amplifier breakout with a pre-soldered terminal block.
Listen to this good news - we now have an all in one digital audio amp breakout board that works incredibly well with the 
guides with product
$5.95
In Stock
Black Nylon Screw and Stand-off Set with M2.5 Threads, kit box
Totaling 380 pieces, this M2.5 Screw Set is a must-have for your workstation. You'll have enough screws, nuts, and hex standoffs to fuel your maker...
guides with product
$16.95
In Stock
Mini USB Microphone dongle
Hey, listen up! It's the world's smallest USB microphone! OK maybe it's not in the Guinness Record Book, but it is pretty darn small! This plug-and-play...
$5.95
In Stock
Square aluminum heat sink with 16 fins
Looking for a nice way to cool down your Raspberry Pi 3? Check out this 14x14x8 Heat...
$1.50
In Stock
Shot of a coiled USB to 2.1mm Male Barrel Jack Cable.
There's two standard ways to power electronics - USB or 5.5mm/2.1mm DC barrel jack. This or that! With this USB to 2.1mm Male Barrel Jack Cable, you can now power...
$2.75
In Stock
Premium Male/Male Jumper Wires - 20 x 6 (150mm) folded over
These Male/Male Jumper Wires are handy for making wire harnesses or jumpering between headers on PCB's. These premium jumper wires are 6" (150mm) long and come in a...
Out of Stock
close up of ends of various small heat shink tubes
Heat shrink is the duct tape of electronics, it keeps your stuff all safe and kept together. Especially when wiring and soldering, use heat shrink to add mechanical strength to cables....
$4.95
In Stock
Angled shot of 2 2-pin JST SM Plug + Receptacle Cable, socket type and plug type.
These 2-wire cables are 16cm long and come as a set.  One side has a 2-pin JST SM type connector plug on the end.  The other side has a matching 2-pin JST SM type...
$0.75
In Stock
Mini Metal Speaker with Wires
Listen up! This tiny 1" diameter speaker cone is the perfect addition to any small audio project where you need an 8 Ω impedance and will be using 0.5W or less of power. We...
$1.95
In Stock
Mini External USB Stereo Speaker
Add some crisp and compact audio to your project with this Mini External USB 2.0 Speaker. It's USB-only and does not require or use a 3.5mm audio jack....
$12.50
In Stock
Top view of a clear plastic storage box opened up with several compartments of variously sized wire ferrules.
Crimping's not just for 80s hair metal bands! When your project requires repeated insertion and removal with minimal strain, why not check out the reliable wire...
$17.95
In Stock
Angled shot of 25 Through-Hole Resistors - 100K ohm 5% 1/4W.
ΩMG! You're not going to be able to resist these handy resistor packs! Well, axially, they do all of the resisting for you!This is a 25 Pack of 100K...
$0.95
In Stock
Angle shot Female DC Power adapter - 2.1mm jack to screw terminal block
If you need to connect a DC power wall wart to a board that doesn't have a DC jack - this adapter will come in very handy! There is a 2.1mm DC jack on one end, and a screw terminal...
$2.00
In Stock
USB Type A to Type C Cable - 1ft - 0.3 meter
As technology changes and adapts, so does Adafruit. This  USB Type A to Type C cable will help you with the transition to USB C, even if you're still...
$3.95
In Stock