Raspberry Pi Zero, micro SD card, cables, headers and case
Featured
Remember those cereal commercials that would always say, "part of a complete breakfast"? Well the Pi Zero's a lot like that bowl of cereal - while it's great on its own, you need a lot of accessories to make it a complete meal.The Pi Zero W...
view other guides that use this product
Out of Stock
Single LED lit up bright green
Need some really bright LEDs? We are big fans of these clear green LEDs, in fact we use them exclusively in our kits. They are very bright and have about 20degree LED beam. They go easily into a breadboard and will add that extra zing to your project.Pack of 25 clear green...
$8.00 each
In Stock
Angled shot of 25 Through-Hole Resistors - 470 ohm 5% 1/4W.
ΩMG! You're not going to be able to resist these handy resistor packs! Well, axially, they do all of the resisting for you!This is a 25 Pack of 470Ω Resistors. More specifically, they are carbon film, through-hole...
$0.75 each
In Stock
Angled shot of Premium Female/Male 'Extension' Jumper Wires - 20 x 3
These Female/Male 'extension' jumper wires for making wire harnesses or jumpering between headers on PCB's. These premium jumper wires are 3" (75mm) long and come in a 'strip' of 20 (2 pieces of each of ten rainbow colors). They have 0.1" male header...
$1.95 each
In Stock
Angled shot of half-size solderless breadboard with red and black power lines.
This is a cute, half-size breadboard with 400 tie points, good for small projects. It's 3.25" x 2.2" / 8.3cm x 5.5cm with a standard double-strip in the middle and two power rails on both sides. You can pull the power rails off easily to make the breadboard as...
$4.95 each
In Stock