STEMMA WireUse the STEMMA QT JST SH-4 cable for the Raspberry Pi Pico. This will plug into the OLED display. Remove the male header pins by cutting them off. Use wire strippers to remove a bit of insulation from the tips of each wire. Tin the exposed strands of wire by adding a bit of solder. |
|
Solder STEMMA to Raspberry Pi PicoAttach the four wires from the STEMMA cable to the bottom of the Raspberry Pi Pico.
|
|
Soldered Pico STEMMA cableDouble check the four wires have been properly soldered to the pins on the Raspberry Pi Pico. |
Wiring STEMMA for Pico
This guide was first published on Mar 10, 2021. It was last updated on 2021-03-10 12:36:29 -0500.
This page (Wiring STEMMA for Pico) was last updated on Apr 10, 2021.
Text editor powered by tinymce.