Hardware for PCB Mount

Use the following hardware for assembling the PCB mount.

  • 4x M3 x 12mm long FF standoffs
  • 4 x M2.5mm x 8mm long FF standoffs
  • 4x M2 x 6mm long FF standoffs
  • 8x M3 x 6mm screws
  • 8x M2 x 4mm screws
  • 8x M2.5 x 4mm screws

Install M3 hardware

Insert M3 screws through the mounting holes on the outer perimeter of the PCB mount. Fasten the M3 standoffs onto the thread of the screw. 

Install M2 Hardware

Insert M2 screws through the mounting holes that are near the M3 standoffs. Fasten the M2 standoffs onto the threads of the screws. 

Install M2.5 Hardware

Flip the PCB over and insert the M2.5 screws through the remaining mounting holes. Fasten the M2.5 standoffs onto the threads of the screws. The M2.5 standoffs should be facing the opposite side. Reference the image for correct placement.

Assembled PCB Mount

Double check the standoffs are tightly fastened and installed in the correct mounting holes. Reference the images, click the thumbnail to enlarge.

This guide was first published on Mar 10, 2021. It was last updated on Jul 22, 2024.

This page (PCB Mount Assembly) was last updated on Mar 08, 2024.

Text editor powered by tinymce.