Solder Ground to OLEDSecure the OLED to a panavise, PCB vise or third helping hands. Solder the remaining ground wire to the ground pin on the OLED breakout. |
|
Connect STEMMA Cables to OLEDPlug in the STEMMA QT cable from the Raspberry Pi Pico to the left port on the side of the OLED. Plug in the STEMMA QT / Qwiic JST SH 4-Pin Cable to the right port on the other side of the OLED. |
|
Hardware for OLEDUse the following hardware to secure the OLED to the top cover.
|
|
Install OLED to Top CoverPlace the OLED face down into the top cover. Line up the mounting tabs with the mounting holes in the top cover. Insert the screws through the holes in the top cover and push them through the mounting holes on the OLED. |
|
Secure OLEDWhile holding screw in place, insert and fasten an M2.5 hex nut onto the thread of the screw. Tightly fasten to secure. Proceed to install the remaining screws. |
Install OLED
This guide was first published on Mar 10, 2021. It was last updated on 2021-03-10 12:36:29 -0500.
This page (Install OLED) was last updated on Apr 15, 2021.
Text editor powered by tinymce.