QT Py Case

3D print yourself a snap fit case to house a QT Py and a STEMMA QT breakout board. The bottom cover has built-in holder for the QT Py that can be secured without any screws!

Modular Design

The top cover has several vents that can be used as mounting holes so you can secure the board in different orientations.

The bottom cover features similar slots so you can mount it to either the top or bottom.

QT Accessories

The case features two mounting tabs for attaching to surfaces. Just snap fit the covers over the framing with the opening lined up for the USB-C Port.

Parts

Angled shot of small square purple dev board.
What has your favorite Espressif WiFi microcontroller, comes with our favorite connector - the STEMMA QT, a chainable I2C port, and has...
$12.50
In Stock
Black Nylon Screw and Stand-off Set with M2.5 Threads, kit box
Totaling 380 pieces, this M2.5 Screw Set is a must-have for your workstation. You'll have enough screws, nuts, and hex standoffs to fuel your maker...
$16.95
In Stock
Angled shot of STEMMA QT / Qwiic JST SH 4-pin Cable.
This 4-wire cable is a little over 100mm / 4" long and fitted with JST-SH female 4-pin connectors on both ends. Compared with the chunkier JST-PH these are 1mm pitch instead of...
$0.95
In Stock
Angled of of JST SH 4-Pin Cable.
This 4-wire cable is 50mm / 1.9" long and fitted with JST SH female 4-pin connectors on both ends. Compared with the chunkier JST PH these are 1mm pitch instead of 2mm, but...
$0.95
In Stock

This guide was first published on Jan 11, 2022. It was last updated on Jan 11, 2022.

This page (Overview) was last updated on Aug 05, 2022.

Text editor powered by tinymce.