PyPortal YouTube Stand

We can 3D print a nice display stand for the PyPortal and add a YouTube themed TV screen-styled bezel to the front.

First, 3D print the PyPortal Stand based on the Ruiz Bros. model and instructions here.

Mounting

 

Add nylon 2.5mm short hex standoffs and nuts to the stand as shown here.

Attach Bezel

 

Align the bezel with the front of the PyPortal so that the light sensor is visible through the bezel's side hole.

 

Use the four nylon M2.5 screws to fasten the bezel and PyPortal to the hex standoffs and stand.

Now, plug it into USB power and you're ready to go!

This guide was first published on Mar 15, 2019. It was last updated on Mar 15, 2019. This page (PyPortal YouTube Stand) was last updated on Oct 30, 2019.