Hardware for Soil Sensor

The STEMMA soil sensor is secured to the sensor plate using 2 x M2.5 x 10mm long screws and hex nuts. 

Install Soil Sensor

Place the STEMMA soil sensor over the sensor plate. Line up the two mounting holes on the PCB with the holes on the plate. Insert two M2.5 x 10mm long screws through the mounting holes. 

Secure Soil Sensor

Insert and fasten an M2.5 hexnut onto the threads of the screws. Finger tighten the two hex nuts.

Install STEMMA Cable

Grab the F/F STEMMA cable and plug it into the port on the soil sensor.

This guide was first published on Feb 05, 2020. It was last updated on Feb 05, 2020.
This page (Sensor Assembly) was last updated on Sep 27, 2020.