Case Assembly

Connect Soil Sensor to PyPortal

Grab the STEMMA cable from the soil sensor and plug it into the STEMMA I2C port on the back of the PyPortal Titano.

Connect Speaker

Grab the cable from the speaker and connect it to the speaker port on the back of the PyPortal Titano.

Install Face Plate to Frame

Insert the PyPortal into the frame. Orient the PyPortal so the USB-C port is lined up with the cut out on the side of the frame. Adjust the wiring from the speaker and soil sensor so they're inside the frame and not being kinked. Press the face plate into the frame firmly to snap fit into place.

Install Speaker to Frame

Fit the speaker into the holder on the side of the case. Press the speaker into the holder from inside the frame.

Install Back Cover

Grab the back cover and orient the snaps with the nubs on the side of the frame. Press the cover into the frame firmly to snap fit into place.

Final Build

And there you have it! The build is ready for potting with soil and watering. The planter has a diameter of 79mm (3in) and a depth of 93mm (3.6in). The drip tray has a depth of 16mm (0.6in).

This guide was first published on Feb 05, 2020. It was last updated on Feb 05, 2020. This page (Case Assembly) was last updated on May 31, 2020.