LIS3DH bracket

Use M2.5x6mm screws to mount the sensor to the bracket, making sure to align with the text up right as shown on the picture

Place PyPortal

Align the PyPortal screen between the standoffs. Place the SD card slot side close to the splash geometry on the printed frame.

The screw mounts closest to the splat geometry use M3x6mm screws.

Wait to add the LIS3DH bracket. 

Plug the 4-pin JST PH to JST SH Cable into the center port. Carefully coil the cable around the port to mange the cable length.

Mount Sensor Bracket

Use M3x10mm screws to mount the sensor bracket.

Make sure the cable wires are not kinked when placing the bracket over the standoffs.

Optional Right angle USB cable

An optional right angle USB cable can be used to route the power to the PyPortal. 

Use a Right Angle Micro B Plug Down, ribbon cable and a micro B socket.

SD Card

Lastly insert an SD card into the slot after copying images to the imgs folder.