To wire up the servo motor to the CLUE, you'll clip the servo's alligator clips to the CLUE's pads located at the bottom of the board. The alligator clips are color coded so that you can tell which connection goes where.
- Servo Data to CLUE pad 0 (white wire)
- Servo Power to CLUE 3V pad (red wire)
- Servo Ground to CLUE GND pad (black wire)
First, make sure that your CLUE is disconnected from power. Then, clip the servo's red alligator clip to the CLUE's 3V pad. This is the power input for the servo.
Next, clip the servo's black alligator clip to the CLUE's GND pad. This is the ground connection for the servo.
Text editor powered by tinymce.
